Foundry Practice

From MeritBadgeDotOrg

Revision as of 17:03, October 1, 2012 by Scouterdennis (Talk | contribs)
Jump to: navigation, search
Foundry Practice merit badge
Status: Discontinued BSA Advancement ID: unavailable
Created: 1923 Original/new/replaced:
Discontinued: 1952 Replaced by:

Contents

[[Category:Discontinued {{{group}}} merit badges]]

Foundry Practice is a discontinued merit badge. Foundry Practice was first offered in 1923. It was discontinued in 1952.

Merit badge requirements

1. (a) Make a freehand working drawing of a flask used for a bench moulding in the foundry; (b) describe same flask.
2. (a) Show by section sketch a mould of a plate 12" long, 6" wide, 1" thick with gate and vents; (b) construct the mould.
3. Make a perspective sketch of a pulley pattern 6" diameter, 2" face, the center to be cored 2" by use of core prints.
4. Construct a wood pattern and core box as per the sketch outlined in Requirement 3; use shrinkage rule for the metal used, gray iron, bronze or brass. Change measurements to allow for finish all over casting and proper draft for removing pattern from mould.
5. Describe how the cupola operates.
6. (a) Describe a process for cleaning one of the above castings when removed from the mould; (b) clean one of the above castings.
7. Describe the properties in sand that are best suited for foundry use and tell how to prepare sand for use.
8. Tell what important safety precautions should be taken to protect the workers in a foundry - by the employer - by the employee.

Note: In each case when a mould is required the pattern must first be made.


Boy Scout Requirements, ({{{1}}}) Edition The official source for the information shown in this article or section is:
Handbook for Boys, 1948 Edition
Personal tools
language